Have you checked the SSL tick box? Is the port number correct?Īre your login details correct? Make sure to use the same email address that you used to create your Supertext account. Make sure the “Login Provider” is set to “SDL Authentication”. Is the server address correct? It should be “”. Please note: the green “Finish job” button will only appear after you have checked the file in.Ī restart often solves many Trados/GroupShare issues – you should always try this first.įirst, check that you have entered the correct server details. You can then go back to the job page on the Supertext portal and click the green “ Finish job” button. Depending on your screen size, this will either appear as a button with the words “Check Out”: This downloads the project from the GroupShare server. You need to check out the file before you can start working on it. Once you’ve done that, click “ Finish”.ĭouble-click on the project to view it in the “ Files”view. Make sure it’s somewhere safe, such as a dedicated GroupShare folder, rather than just your downloads folder. Select a location to save the project in. Once you’ve accepted the job, you’ll see the following information box:Ĭlick on the “Click here to open this GroupShare project” link. Opening a GroupShare project via the job page on the Supertext portalĪccept the job in the Supertext system. ![]() ![]() There are two ways you can open a GroupShare project: via a link on the job page in our freelancer portal, or directly in Trados. Once you’ve followed the steps above to set up the GroupShare server, you can now open your GroupShare project.
0 Comments
Leave a Reply. |